Ivano is used for superficial wrinkles, such as crow's feet, and can also be used for tissue filling and lip augmentation. In addition, if it is applied in the same area, only fine can be used. Original is used for medium wrinkles and can also be used for tissue filling, but it can never be used for crow's feet. Ultra is used for deeper wrinkles, but it cannot be used for crow's feet and lips. Evolution can be used for wrinkles, tissue filling and lip augmentation in people over the age of 45, but don't use Evolution to inject lighter wrinkles such as crow's feet. 1. Forehead pattern: Generally, Original and Ultra can be used to select which product to apply according to the depth of wrinkles. First, the injection area is delineated and injected into the area in a radial manner. When the injection is performed, the needle is inclined upward, and the wrinkle is used with the index finger. And the middle finger stretches flat, the tip of the needle and the skin wrinkle at the deepest angle of 30-45 degrees, when the needle tip enters the dermis layer of the skin, the angle gradually becomes smaller, and continues to enter the needle along the depth of the wrinkle to ensure that the whole needle is in the dermis Under the layer, slowly reverse the edge, the contents of the syringe are pushed under the dermis, and it is forbidden to inject into the fat layer or below. The total dosage is about 1ml. Generally, it can be injected once every 1-2 months. It is fine, injected into the dermis layer, and the remaining wrinkles are removed. 2. Eyebrow pattern: Generally, ultra or evolution is used. Firstly, the injection area is delineated and injected into the area in a radial manner. When the injection is performed, the needle is inclined upwards, the wrinkles are flattened with the index finger and the middle finger, and the needle tip and the skin fold are deepest. At an angle of 30-45 degrees, when the needle tip enters the dermis layer of the skin, the angle gradually becomes smaller, and the needle continues to enter the needle along the depth of the wrinkle, ensuring that the whole needle is under the dermis layer, slowly reversing the injection edge, the syringe The contents are pushed under the dermis and are not allowed to be injected into the fat layer or below. The total dosage is about 1ml. The eyebrow lines should be filled after injection. Generally, the injection can be made once in 1-2 months. Fine, injection into the dermis layer to remove the remaining wrinkles. 3, crow's feet: Crow's feet can only be treated with fine, generally parallel to the needle, the dermis and subcutaneous soft tissue peeling, a small amount of some fine to isolate, the effect is very good. 4, nasolabial folds: generally use ultra or evolution, first delineate the injection area, because the nasolabial foldFor the gravity drooping, so the area generally selects the nasolabial triangle area, that is, the inner side of the nasolabial fold, above the tangential line of the lip, the dynamic wrinkles on the corner of the mouth, that is, the nasolabial line extension is prohibited from injection. The radiation is tilted into the area to ensure that the entire needle is in the dermis layer or under the skin, while reversing, slowly pushing the contents of the syringe into the deep or subcutaneous layer of the dermis. The total dosage is about 1-1.5ml. Generally, it can be injected once every 1-2 months. Fine, injection into the middle layer of the dermis, and remove the remaining wrinkles, about 0.5ml. The product cannot be injected directly under the nasolabial fold during injection. 5, the mouth drooping and the corner line: Generally use original, first delineate the injection area, because the mouth line is generally aging and depression, so the area is selected as the inner side of the lower edge of the mouth, sprayed into the area in a radial manner, to ensure the whole root The needles are all deep or subcutaneous in the dermis, and the contents are reversed, and the contents of the syringe are slowly pushed into the deep or subcutaneous layers of the dermis. The total amount is about 1 ml. 6, lip lip: generally use fine or original, according to the needs of patients generally have three injection methods. The first type, the lip line, aims to make the ordinary lips thick and protruding, full and sexy. Inject a week along the lip and inject it under the mucosal layer. Avoid too much and too much. The second, full of lips, the purpose is to make the dry lips full and sexy. It is filled radially along the corner of the mouth to ensure that the whole needle is under the mucosa and above the muscle layer. The amount is small, and the content is reversed. The contents of the syringe are slowly pushed in. The whole lip can be filled three times. , about a month apart. The third type, the wind lip is sunken, according to the patient's request, the part of the lip is filled in a radial tiled area, and the injection method is the same as the second type. The total dosage is about 0.5-1.5ml. The dosage should be strictly controlled for each injection. 7, long bones, ridges, ridges and jaws: generally use original or ultra, first delineate the injection area, should ensure that the two sides are symmetrical, radial injection into the area, to ensure that the entire needle is even under the skin While reversing, slowly push the contents of the syringe into the skin. The total dosage is about 2-3ml, which must be divided into multiple injections. Care should be taken to avoid damage to the superficial arteries and veins. When the mandibular jaw is mastered, the patient is required to prolong or slightly tilt, prolonged to be periosteal injection, and micro-warp is injected into the skin subcutaneously. Should avoid injury to the facial artery.